Heavy Grade

Heavy Grade

*Requires a minumum of 2" x 10" lumber. This is our Heavy Duty wood dock hardware. This hardware is made of 3/8" thick steel, 8" tall, and all pins use 1" Diameter pins. To view our other hardware types click here. All steel hardware is HOT DIPPED GALVANIZED after fabrication.

Display: List / Grid
Show:
Sort By:
Angle Brace - HD
Angles are used to attach interior stringers to the exterior frame. Use with 2 HD-W Washer plates to..
$8.99
Backup Plate - HD
Use the Backup Plate for additional strength behind HD-SM or HD-SF. Use with 1/2" carriage bolts. ..
$8.99
Cleat Angle - HD
Use the cleat angle under your cleats and decking to strengthen your cleats. This enables you to tie..
$8.99
Heavy Duty 3" Pipe Holder
This heavy duty 3" Pipe holder bolts to the side of a dock using ½" carriage bolts. The length of bo..
$24.86
Inside Corner - HD
Inside corners are used with an outside corner to sandwich the wood together to create a very strong..
$27.95
Outside Corner End - HD
The outside corner end is used for the ends of docks or fingers. Good for square platforms. Use 1/2"..
$29.12
Outside Corner Female - HD
Outside corner female has 2-1/2" tabs with a hole for 1" bolt or pin. Use with HD-OCM or HD-SM to cr..
$44.91
Outside Corner Female/Female - HD
Use the outside corner female/female on docks where you need to hinge two sections on a corner. This..
$60.69
Outside Corner Male - HD
Outside corner male has 2-1/2" tabs with holes for a 1" bolt or pin. Use with HD-OCF or HD-SF to cre..
$37.02
Outside Corner Male/Female - HD
Use the outside corner female/male on docks where you need to hinge two sections on a corner. This n..
$52.81
Outside Corner Male/Male - HD
Use the outside corner male/male on docks where you need to hinge two sections on a corner. This nee..
$44.91
Single "T" Female - HD
Single "T" female has two 1/2" tabs with a hole for 1" bolt or pin. Use with HD-SM and bolt to the s..
$24.94
Single "T" Male - HD
A single "T" male has one 1/2" tab with a hole for a 1" bolt or pin. Use with HD-SF and bolt to the ..
$16.83
Washer Plate - HD
Washer Plates (HD-W) are used primarily with Angles (HD-A) and Cleat Angles (HD-CA). The Square hole..
$4.34