This is our
Lightweight wood dock hardware. This hardware is made of 3/16" steel, 5" tall, and all pins use 3/4" diameter pins. Use 3/8" carriage bolts for assembly. To view our other hardware types click here. All steel hardware is HOT DIPPED GALVANIZED after fabrication.
Name (A - Z)
Name (Z - A)
Price (Low > High)
Price (High > Low)
Model (A - Z)
Model (Z - A)
Inside corners are used with an outside corner to sandwich the wood together to crea..
The outside corner end is used for the ends of docks or fingers. Good for square platforms. Use 3/8"..
Outside corner male has 2-1/2" tabs with holes for a 3/4" bolt or pin. Use with HL-OCF or HL-SF to c..
Outside corner female has 2-1/2" tabs with a hole for 3/4" bolt or pin. Use with HL-OCM or HL-SM to ..
A single "T" male has one 1/2" tab with a hole for a 3/4" bolt or pin. Use with HL-SF and bolt to th..
Single "T" female has two 1/2" tabs with a hole for 3/4" bolt or pin. Use with HL-SM and bolt to the..
Use the backup plate for additional strength behind HL-SM or HL-SF. Use with 3/8" carriage bolts.
Angles are used to attach interior stringers to the exterior frame. Use with 2" HL-W Washer plates t..
Use the cleat angle under your cleats and decking to strengthen your cleats. This enables you to tie..
Washer plates are used with to strengthen the bolt connection anywhere bolts are used with other har..
Use the outside corner female/female on docks where you need to hinge two sections on a corner. This..
Use the outside corner male/male on docks where you need to hinge two sections on a corner. This nee..
Use the outside corner male/female on docks where you need to hinge two sections on a corner. This n..
The outside corner end with a 2" pipe holder is used in place of a standard HL-OCE if you need a pla..
The chain retainer is used to hold chain to a dock. Use 1/2" chain or less. Use with HL-W washer pla..
The HL-SP splice plate is used to splice lumber together. You can splice two 8' sections of 2x8 lumb..