This is our Standard wood dock hardware. This hardware is made of 1/4" thick steel, 5" tall, and all pins use 3/4" diameter pins. Use 1/2" carriage bolts for assembly. To view our other hardware types click here. All steel hardware is HOT DIPPED GALVANIZED after fabrication.
Inside corners are used with an outside corner to sandwich the wood together to create a very strong..
The outside corner end is used for the ends of docks or fingers. Good for square platforms. Use 1/2"..
Outside corner male has 2-1/2" tabs with holes for a 3/4" bolt or pin. Use with H-OCF or H-SF to cre..
Outside corner female has 2-1/2" tabs with a hole for 3/4" bolt or pin. Use with H-OCM or H-SM to cr..
A single "T" male has one 1/2" tab with a hole for a 3/4" bolt or pin. Use with H-SF and bolt to the..
Single "T" female has two 1/2" tabs with a hole for 3/4" bolt or pin. Use with H-SM and bolt to the ..
Use the Backup Plate for additional strength behind H-SM or H-SF. Use with 1/2" carriage bolts.
Angles are used to attach interior stringers to the exterior frame. Use with 2 H-W Washer plates to ..
Use the cleat angle under your cleats and decking to strengthen your cleats. This enables you to tie..
Washer plates are used with to strengthen the bolt connection anywhere bolts are used with other har..
Use the outside corner female/female on docks where you need to hinge two sections on a corner. This..
Use the outside corner male/male on docks where you need to hinge two sections on a corner. This nee..
This 3" Pipe holder bolts to the side of a dock using ½" carriage bolts. The length of bolt you use ..
Use the outside corner female/male on docks where you need to hinge two sections on a corner. This n..
The inside corner with a 3" pipe holder replaces the standard inside corner (H-IC) and creates a pla..
The outside corner end with a 3" pipe holder is used in place of a standard H-OCE if you need a plac..
The chain retainer is used to hold chain to a dock. Use 1/2" chain or less. Use with H-W washer plat..
The H-SP splice plate is used to splice lumber together. You can splice two 8' sections of 2x8 lumbe..
Use the H-135 to build in a 45 degree angle on your dock to spread out the load of an attached dock ..
Our single pipe holder is designed to be mounted to a stationary piling, and used in sets of 2, to h..
The non-articulating outside corner female hardware is compatible with our standard wood dock hardwa..
The non-articulating outside corner male hardware is compatible with our standard wood dock hardware..
The non-articulating single "T" female hardware is compatible with our standard wood dock hardware H..
The non-articulating single "T" male hardware is compatible with our standard wood dock hardware H-B..